11/18/2023 0 Comments Cadimage for archicad 25We just upgraded from AC24 a few days ago and were exploring the cabinet changes which were kind of excited about because they are supposed to be a lot more customizable (which they are) but they do have some major drawbacks which make them almost unusable. Very valid points you make here In Cortasia especially about the corner cabinet doors. I have just found it frustrating that Stair can do everything but make my lunch, but the cabinet tool, doesn't make a nice cabinet? I use the Morph constantly for Interiors, but the cabinets have always been lame and terrible. But honestly, I am super happy Graphisoft are finally looking at the Cabinetry. There is tonnes more, more as I go through, it is holidays and I am off for a few days. If we can't show tight drawings, we are relying on Cabinet-Makers and Joiners to do it properly, and they never will, if we don't show it properly. This is major problem in producing elegant tight work. In my previous image, I display problems with door and shelf alignments. It is great having the Bevel/Finger-pull/Shark-Nose whatever you call it, has been 15year over due! But there should not be gap when applied. With pivot (world) or hinge (Aus/NZ) options.Ĥ. Just showing lines as they should appear in elevation, or in 3D if one wishes. The workings of this Corner Unit needs some reviewing.ģ. These doors in a corner module should meet together, if you the designer wants them to. Make it an unusable function, need to add a wall to make an end panel. The Front Side Connection, I have selected flush as you can see it is not. There needs to be an overhaul of the line displays, basics plan display of old versions, full, front/back, front/back & left side and front/back & right side are gone?Īnd finishes, can they not be only in 'Representation', it was previously The plan display in for Cabinet makers, not designers, which Archicad is for. Secondly, I cannot see where to turn on opening line/symbol in the elevation? (Again we use Cadi-image cabinets) They are required more on the elevations than they are in plan. Terms like 'side hung' are made up, please have some research done. Start with basic terminology, I know the planet uses different terms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |